How To Install Solid Edge St2 On Windows 7
A foundation is required to ensure loads from the building are sustained and safely transmitted to the ground. All load bearing elements, these include external walls, party walls, chimney breasts, piers and internal load bearing walls should sit on an adequate foundation. • Foundation trenches should be excavated down to consistent and competent virgin ground which provides adequate bearing strength. • In chalk soils foundation depths can be as little 500-750mm, but no less than 450mm to protect against frost action. • In sand and clay soils the depth of foundations should be no less than 900mm deep and BS8103 recommends a depth of not less than 1.0m. • In clay soils affected by seasonal moisture, foundations over 2.5m deep are not normally acceptable, in which case piles, raft or pad and beam foundations may be required.
Additionally, some soils can be affected by particular species of trees and deeper foundations or special foundation types may be required (see below). • When digging the trenches for the foundation, all existing services and nearby drains should be supported and protected.
• However, if the drain is no longer in use, it should be removed or opened up and filled with concrete • Divert the drain if damage to the drain is possible & the drain is still in use. • The design of the foundations should account for the effect of any nearby drainage trench on the newly excavated foundations. Any service trenches or other excavations should be above the 45 degree line extending down from the bottom of the foundation, as shown below. NB Reference should also be made to NHBC Chapter 5.3 'Drainage Below Ground'. • Foundation trenches should be straight and even with horizontal bottoms and vertical sides.
In comparison to the total number of users, most PCs are running the OS Windows 7 (SP1) as well as Windows XP. Installation folder: C: Program Files solid edge st2 program. Or, you can uninstall Solid Edge ST2 from your computer by using the Add/Remove Program feature in the Window's Control Panel. I am having a problem to install the Solid Edge v15. The operating system of my PC is Windows 7. Each time I try to install, it gets stuck at certain stage and the. Conduire Un Vehicule De Promenade Pdf here.
• They should be compact and reasonably dry, rebottoming will be required if the trenches are allowed to crack or become water filled. • The excavations should be taken below visible roots (especially in clay soils) and any loose material must be removed before the concrete is poured. • The thickness of a strip foundation should be between 150mm and 500mm.
300mm thickness is used in most small domestic works. • Strip foundations are usually at least 600mm wide as this tends to be the width of the digger bucket although on sand, silt or soft clay, it may be necessary to provide foundations as wide as 850mm. • The width of a trench foundation can be reduced to 450mm if ground conditions permit, although the brick layer may struggle to lay the bricks and blocks in a narrow trench. However there should always be 50mm projection from the brick outer face to the edge of the foundation concrete. • Trench foundations can be dug deeper than strip, which means they are particularly practical where the water table is high, where soil is loose and unstable, and in areas with heavy clay soils. • The trench sides may need to be lined with a slip membrane unless the soil is firm.